Lantronix UDS1100 User's Guide download pdf (Page 64)

UDS1100 User Guide 64

Monitor Mode is a command-line interface used for diagnostic purposes.

There are two ways to enter Monitor Mode: locally using the serial port or remotely

using the network.

Entering Monitor Mode Using the Serial Port

To enter Monitor Mode locally:

1. Follow the same steps used for setting the serial configuration parameters

(see Serial Port on page 37).

2. Instead of typing three x keys, however:

a) Type zzz (or xx1) to enter Monitor Mode with network connections.

b) Type yyy (or yy1) to enter Monitor Mode without network connections.

A 0> prompt indicates that you have successfully entered Monitor Mode.

Entering Monitor Mode Using the Network Port

To enter Monitor Mode using a Telnet connection:

1. Establish a Telnet session to the configuration port (9999). The following

message appears:

2. Type M (upper case) immediately.

A 0> prompt indicates that you have successfully entered Monitor Mode.

Monitor Mode Commands

The following commands are available in Monitor Mode. Many commands have an IP

address as an optional parameter (xxx.xxx.xxx.xxx). If you enter the IP address, the

command is applied to another unit with that IP address. If you do not enter the IP

address, the command is executed locally.

Note: All commands must be in capital letters. Responses to some of the

commands are in Intel Hex format.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 83 84

No comments

Lantronix UDS1100 User's Guide Page 64