Lantronix UDS1100 User's Guide download pdf (Page 45)

7: Setup Mode: Channel Configuration

UDS1100 User Guide 45

b) Response

Character Response A single character is transmitted to the serial port when there is a

change in connection state:

C = connected, D = disconnected, N = host unreachable.

This option is overridden when the Active Start Modem Mode

or Active Start Host List is in effect. Default setting is Nothing

(quiet).

c) Active Startup

No Active Startup Does not attempt to initiate a connection under any

circumstance. Default setting.

With Any Character Attempts to connect when any character is received from the

serial port.

With Modem Control In

Active

Attempts to connect when the Modem Control In input is

asserted.

With a Specific Start

Character

Attempts to connect when it receives a specific start character

from the serial port. The default start character is carriage return.

Manual Connection Attempts to connect when directed by a command string

received from the serial port. The first character of the command

string must be a C (ASCII 0x43), and the last character must be

either a carriage return (ASCII 0x0D) or a line feed (0x0A). No

blanks or space characters may be in the command string.

Between the first and last command string characters must be a

full or partial destination IP address and may be a destination

port number.

The IP address must be in standard decimal-dot notation and

may be a partial address, representing the least significant 1, 2,

or 3 bytes of the remote IP address. The period is required

between each pair of IP address numbers.

If present, the port number must follow the IP address, must be

presented as a decimal number in the range 1-65535, and must

be preceded by a forward slash (ASCII 0x2F). The slash

separates the IP address and the port number. If you omit the

port number from a command string, the internally stored remote

port number starts a connection.

If a partial IP address is presented in a command string, it is

interpreted to be the least significant bytes of the IP address and

uses the internally stored remote IP address to provide the most

significant bytes of the IP address. If the IP address entered is

0.0.0.0/0, the device server enters Monitor Mode.

For example, if the remote IP address already configured in the

unit is 129.1.2.3, then an example command string would be

C3/7. (This would connect to 129.1.2.3 and port 7.) You may

also use a different ending for the connection string. For

example, C50.1/23 would connect you to 129.1.50.1 and port 23.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 83 84

Comments to this Manuals

No comments

Lantronix UDS1100 User's Guide Page 45

Comments to this Manuals

Related products and manuals for Serial servers Lantronix UDS1100