Lantronix UDS1100 User's Guide download pdf (Page 38)

UDS1100 User Guide 38

This chapter explains how to configure the network settings.

Note: Current values display in parentheses.

Server Configuration (Option 0)

The unit’s basic network parameters display when you select Server configuration

(option 0). The IP Address, Set Gateway IP Address, and Netmask fields display

the current values.

Figure 6-1. Network Settings

IP Address : (000) .(000) .(000) .(000)

Set Gateway IP Address (N)

Netmask: Number of Bits for Host Part (0=default) (0)

Change telnet config password (N)

IP Address

If DHCP is not used to assign IP addresses, enter the IP address manually. The IP

address must be set to a unique value in the network. Enter each octet and press

Enter between each section. The current value displays in parentheses.

IP Address : (000) (000) (000) (000) _

If DHCP is used, the third octet of the IP address sets the BootP/DHCP/AutoIP

options. The following table shows the bits you can manually configure to force the

UDS1100 to disable AutoIP, DHCP, or BootP. To disable an option, set the

appropriate bit.

Table 6-1. BootP/DHCP/AutoIP options

Options Bit

Value

AutoIP 0 1

DHCP 1 2

BootP 2 4

For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are

disabled; only DHCP is enabled. (The value 5 results from adding the binary

equivalents of 0 and 2.) This is the most common setting when using DHCP.

Set Gateway IP Address

The gateway address, or router, allows communication to other LAN segments. The

gateway address should be the IP address of the router connected to the same LAN

segment as the unit. The gateway address must be within the local network. The

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 83 84

No comments

Lantronix UDS1100 User's Guide Page 38