Lantronix SecureBox SDS1101 User's Guide download pdf (Page 46)

7: Setup Mode: Channel Configuration

SDS1101/2101 User Guide 46

Use the following table to select flow control options:

Table 7-3. Flow Control Options

Flow Control Option

Hex

No flow control 00

XON/XOFF flow control 01

Hardware handshake with RTS/CTS lines

XON/XOFF pass characters to host

Port Number

The setting represents the source port number in TCP connections. It is the number

that identifies the channel for remote initiating connections.

Port No (10001) ? _

The default setting for Port 1 is 10001, and for Port 2 is 10002 (SDS2101 only). The

range is 1-65535, except for the following reserved port numbers:

Table 7-4. Reserved Port Numbers

Warning: We recommend that you not use the reserved port numbers

for this setting as incorrect operation may result.

Use Port 0 for the outgoing local port to change with each connection. The port range

is 50,000-59,999. Each subsequent connection increments the number by 1 (it wraps

back around to 50,000).

Only use this automatic port increment feature to initiate a connection using TCP. Set

the port to a non-zero value when the unit is in a passive mode or when using UDP

instead of TCP.

Connect Mode

Connect Mode defines how the unit makes a connection, and how it reacts to

incoming connections over the network.

ConnectMode (C0) ? _

Enter Connect Mode options in hexadecimal notation. The default setting is C0.

Note: All bit positions in the table that are blank represent “don’t care” bits for

that particular option, which can be set to either a 0 or 1 value.

Port Numbers

Reserved for

1 – 1024

Reserved (well known ports)

9999 Telnet setup

14000-14009 Reserved for Redirector

30704 Reserved (77F0h)

30718 Reserved (77FEh)

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 95 96

No comments

Lantronix SecureBox SDS1101 User's Guide Page 46