Lantronix SecureBox SDS1101 User's Guide download pdf (Page 35)

4: Configuration Using Web-Manager

SDS1101/2101 User Guide 35

Use the terminal name for the Telnet terminal type. Enter only

one name. When this option is enabled, the unit also reacts to

the end of record (EOR) and binary options, which can be

used for applications such as terminal emulation to IBM hosts.

Connect Response A single character is transmitted to the serial port when there

is a change in connection state. The default setting is None.

Use Hostlist

If this option is set to True, the device server scrolls through

the host list until it connects to a device listed in the host list

table. Once it connects, the unit stops trying to connect to any

others. If this connection fails, the unit continues to scroll

through the table until it connects to another IP in the host list.

The host list is disabled for Manual Mode and for Modem

Mode. The unit will not accept a data connection from a

remote device when the host list option is enabled.

LED

Select Blink for the status LEDs to blink upon connection, or

select None for no LED output. The default setting is Blink.

Disconnect Mode

On Mdm_Ctrl_In Drop

Set to Yes for the network connection to or from the serial port

to disconnect (drop) when Modem Control In (DSR for

SDS1101) transitions from a high state to a low state. The

default setting is No.

Hard Disconnect

When set to Yes, the TCP connection closes even if the

remote site does not acknowledge the disconnect request.

With EOT

Select Yes to drop the connection when Ctrl-D or Hex 04 is

detected. Both Telnet Com Port Cntrl and Check EOT

(Ctrl+ D) must be enabled for Disconnect with EOT to

function properly. Ctrl+D is only detected going from the serial

port to the network. The default setting is No.

Inactivity Timeout

Use this parameter to set an inactivity timeout. The unit drops

the connection if there is no activity on the serial line before

the set time expires. Enter time in the format mm:ss, where m

is the number of minutes and s is the number of seconds. To

disable the inactivity timeout, enter 00:00.

3. When you are finished, click the OK button.

4. On the main menu, click Apply Settings.

Connection Settings - UDP

To configure a channel’s UDP settings:

1. On the main menu, click Connection. The Connection Settings window for the

selected channel displays.

2. In the available fields, enter or modify the following information:

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 95 96

Comments to this Manuals

No comments

Lantronix SecureBox SDS1101 User's Guide Page 35

Comments to this Manuals

Related products and manuals for Serial servers Lantronix SecureBox SDS1101