3: Getting Started
SDS1101/2101 User Guide 16
Installing the SDS
Figure 3-1. SDS1101 Connected to Serial Device and Network
To install the unit:
Complete the following steps in order. Refer to the numbers in the figure above.
Note: See the sections that follow for details about connectors and pinouts.
1. Connect a serial device to your unit.
2. Connect an Ethernet cable to the RJ45 port.
3. Supply power to your unit using the power supply that was included in the
packaging.
Note: The required input voltage is 9-30 VDC (center +) or 10-24 VAC
(1.5W maximum power required).
4. Supply power to the serial device.
Note: If you encounter a problem, please see LEDs for diagnostic
information.
Comments to this Manuals