Lantronix XPort User Manual download pdf (Page 13)

3: Getting Started

XPort™ User Guide 13

a) Click the Start button on the Task Bar and select Run.

b) Enter your CD drive letter, colon, backslash, Launch.exe (e.g.,

D:\Launch.exe).

3. Click the DeviceInstaller button. The installation wizard window displays.

4. Respond to the installation wizard prompts.

Note: For more information about Device Installer, see the

DeviceInstaller User Guide on the product CD and the DeviceInstaller

online help.

Assigning an IP Address

The unit’s IP address is normally set to 0.0.0.0 at the factory. The hardware address

is on the product label. The unit is DHCP enabled as the default.

To manually assign an IP address:

1. Click StartÆPrograms Æ LantronixÆDeviceInstallerÆDeviceInstaller. If your

PC has more than one network adapter, a message displays. Select an adapter

and click OK.

Note: If the unit already has an IP address (e.g., DHCP has assigned an

IP address), click the Search icon and select the unit from the list of

Lantronix device servers on the local network.

2. Click the Assign IP icon

3. If prompted, enter the hardware address (on the product label) and click Next.

4. Select Assign a specific IP address and click Next.

5. Enter the IP address. The Subnet mask displays automatically based on the IP

address; if desired, you may change it. On a local network, you can leave the

Default gateway blank (all zeros). Click Next.

6. Click the Assign button and wait several seconds until a confirmation message

displays. Click Finish.

7. Select the device from the main window list and select Ping from the Tools

menu. The Ping Device dialog box shows the IP address of the selected unit.

8. From the Tools menu, click the Ping button. The results display in the Status

window. Click the Clear Status button to clear the window so you can ping the

device again.

Note: If you do not receive “Reply” messages, make sure the unit is

properly attached to the network and that the IP address assigned is

valid for the particular network segment you are working with. If you are

not sure, check with your systems administrator.

9. Click the Close button to close the dialog box and return to the main window.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 56 57

No comments

Lantronix XPort User Manual Page 13