Lantronix XPort User Manual download pdf (Page 22)

4: Using Setup Mode for Configuration

XPort™ User Guide 22

3. To enter the Setup Mode, press Enter within 5 seconds. The configuration

settings display, followed by the setup menu options.

Figure 4-2 Setup Menu Options

Change Setup:

0 Server configuration

1 Channel 1 configuration

3 E-mail settings

5 Expert settings

6 Security

7 Factory defaults

8 Exit without save

9 Save and exit Your choice

4. Select an option on the menu by entering the number of the option in the Your

choice ? field and pressing Enter.

5. To enter a value for a parameter, type the value and press Enter, or to confirm a

current value, just press Enter.

6. When you are finished, save the new configurations (option 9). The unit reboots.

Using the Serial Port

To initially configure the unit through a serial connection:

1. Connect a console terminal or PC running a terminal emulation program to your

unit's serial port. The default serial port settings are 9600 baud, 8 bits, no parity,

1-stop bit, no-flow control.

2. To enter Setup Mode, reset the unit, either by pushing the red reset button, or

cycling the unit's power (power off and back on). The self-test will begin. You

have one second to enter three lowercase x characters (xxx).

Note: The easiest way to enter Setup Mode is to hold down the x key at

the terminal (or emulation) while resetting the unit.

3. At this point, the screen display is the same as when you use a Telnet

connection. To continue, go to step 4 in Using a Telnet Connection on page 21.

The following figure shows all of the configuration parameters. The remainder of this

chapter describes each parameter in detail.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 56 57

No comments

Lantronix XPort User Manual Page 22