Lantronix XPress-DR-IAP User's Guide download pdf (Page 102)

UDP

To get and set the node configuration, 120 bytes should be exchanged at once in 32-Byte

records. The IP address in the record (bytes 0 to 3) will be ignored (unless the UDP FD

command is being used).

8.2.4 Calculating the Checksum

As mentioned in Table 24 - Block Types above, the last two characters of an Intel Hex setup

record represent a checksum of the data in the line. Since the checksum is a two-digit

hexadecimal value, it can represent a value from 0 to 255.

The checksum is calculated by summing the value of the data on the line and taking the two’s

complement of the sum.

Note: Do not include the leading colon or the checksum byte in the sum.

Example:

0300300002337A1E

Record length: 03 (3 bytes of data)

Address: 0030 (the 3 bytes will be stored at 0030, 0031, and 0032)

Record Type: 00 (normal data)

Data: 02, 33, 7A

Checksum: 1E

03 + 00 + 30 + 00+ 02 + 33 + 7A = E2

The two’s complement of E2 is 1E. See Calculating the Two’s Complement below.

8.2.5 Calculating the Two’s Complement

The two’s complement of a number is the value that must be added to the number to reach a

Hexadecimal value of 100 (256 in decimal). In the example above, E2 + 1E = 100.

You can also calculate the two’s complement by subtracting the sum from 100. Using the

example above again, 100 - E2 = 1E. It may help to use a scientific calculator.

8-6 DSTni-XPress DR User Guide

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 148 149

No comments

Lantronix XPress-DR-IAP User's Guide Page 102