Lantronix ETS16PR User Manual download pdf (Page 55)

Pinouts

ETS Installation Guide 55

Figure C-5. Wire Splicer

To splice the wires, cut off the end of the wire that does not extend through the

connector and insert both wires into the connector. Make sure that the wire that does

not extend through the connector is in as far as possible to ensure a solid

connection. Make sure that the wire that does extend through the connector extends

far enough on the other side to be inserted in to the DB25 connector. Carefully

squeeze the connector using a pair of pliers to make sure it is fully latched.

RJ45 to DB9

Figure C-6. RJ45-DTE DB9 Adapter

The arrows in Figure C-6 represent the direction of the signal. The pinouts assume

that the 8-conductor cable connecting the ETS and the adapter block is a

swapped\rolled serial cable. Both the transmit and receive ground signals on the ETS

connector are wired to the signal ground on a DB9 adapter.

The information about crimping the RJ45 ground wires in RJ45 to DB25 applies to

the DB9 connector as well.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

No comments

Lantronix ETS16PR User Manual Page 55