Lantronix ETS16PR User Manual Page 11
- Page / 68
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Installation
ETS Installation Guide 11
To install the ETS, complete the following steps in order. Refer to the numbers in the
previous figure.
1. Select a location for the ETS.
When choosing a location, keep in mind the environmental restrictions discussed
in E:Specifications.
2. Connect one or more serial devices to the ETS.
Note: The default serial port settings are 9600 baud, 8 bit characters, no
parity, 1 stop bit, and Xon-Xoff flow control. See C:Pinouts for
information on what kinds of device attachments the ETS supports.
3. It is recommended to connect a terminal to the ETS console port (port 1). This
will enable you to receive diagnostic and initial configuration messages.
4. Connect an Ethernet cable to either the 10BASE-T port (shown) or a transceiver
connected to the AUI port.
Note: The ETS will boot without a valid Ethernet connection, but it will
pause to print a message (seen on the console port) asking if you want
to stop at the Boot> prompt. If you do not respond to this message, it will
wait for 10 seconds and then finish booting.
5. Attach one end of the power cable to the ETS and plug the other end into an
electrical outlet.
6. Flip the power switch to turn the unit ON. The ETS will go through two steps to
begin normal operation:
a) It runs through a set of power-up diagnostics for approximately 12 seconds.
The LEDs show varying patterns corresponding to the tests being run.
b) It tries to obtain TCP/IP configuration information via DHCP, BOOTP, and
RARP. This may take as long as 15 seconds if no hosts answer the requests.
During this step, the OK LED blinks approximately 3 times per second and
the NET LED blinks occasionally.
7. Install EZWebCon on your 32-bit Windows PC computer. The EZWebCon
software is located on the distribution CD-ROM. Alternatively, download it from
ftp://ftp.lantronix.com
.
ETSPR Product Descriptions
ETS16PR Front Panel
The ETS16PR has 16 RJ45 serial ports, a Reset button, an AUI Ethernet port, an
RJ45 Ethernet port for 10/100BASE-T, several LEDs, and a power switch.
Figure 2-4. ETS16PR Front Panel
Note: The first RJ45 port is also the serial console port. Use it as a method for the
initial setup or troubleshooting.
- ETS Installation Guide 1
- Contacts 2
- Copyright and Trademark 2
- Disclaimer and Revisions 3
- Contents 4
- E: Specifications 60 6
- Supported Serial Protocols 7
- How to Use This Manual 8
- ETSP Product Descriptions 9
- Installing the ETSP 10
- ETSPR Product Descriptions 11
- Installing the ETSPR 12
- Configuration Methods 15
- TCP/IP Configuration 16
- Using a Directed Ping Packet 17
- Console Server Example 19
- Define the Menus 20
- Enable Menu Mode 21
- Configure Switches 21
- Using Menus 22
- Serial Tunnel Example 23
- UDP Configuration 24
- Comm Port Redirector 24
- LPR Printing 25
- (x) enable 29
- LPR on Windows 95/98 32
- LPR on UNIX Hosts 32
- LPR on AIX Hosts 33
- LPR on HP Hosts 34
- LPR on SCO UNIX Hosts 34
- RTEL Functionality 35
- Unix Host Troubleshooting 36
- NDPS Printing 37
- NDS Print Queues 37
- PCONSOLE Print Queues 38
- NetWare Host Troubleshooting 39
- NetWare Configuration 40
- ETS Installation Guide 40
- ETS Installation Guide 41 41
- Printing Directly to a Port 42
- LAT Host Troubleshooting 42
- LAT Configuration 43
- ETS Installation Guide 43 43
- Bitronics 44
- Macintosh Services 44
- AppleTalk Zones 44
- AppleTalk Configuration 45
- ETS Installation Guide 45 45
- DLC Configuration 46
- Power-up Troubleshooting 48
- DHCP Troubleshooting 49
- BOOTP Troubleshooting 49
- RARP Troubleshooting 50
- Ethernet Connector 53
- RJ45 Serial Connectors 53
- RJ45 to DB9 55
- Obtaining Software 56
- Reloading Software 57
- NetWare 58
- Updating Software 59
- ETS Installation Guide 59 59
- Power Information 60
- Environmental Limitations 60
- Conventions 61
- Server Commands 61
- Frequently-Used Commands 62
- ETS Installation Guide 63 63
- Port Commands 64
- Protocol Commands 65
- Declaration of Conformity 67
- Warranty 68
Related products and manuals for Hardware Lantronix ETS16PR
Hardware Lantronix UDS100 User Manual
(78 pages)
(78 pages)
Hardware Lantronix XPORT 900-563 User Manual
(12 pages)
(12 pages)
Hardware Lantronix Ethernet User Manual
(92 pages)
(92 pages)
Hardware Lantronix XPort AR User Manual
(142 pages)
(142 pages)
Hardware Lantronix XPort User Manual
(87 pages)
(87 pages)
Hardware Lantronix TS-DDH User Manual
(20 pages)
(20 pages)
Hardware Lantronix UDS2100 User Manual
(83 pages)
(83 pages)
Hardware Lantronix UBOX 2100 User Manual
(79 pages)
(79 pages)
© 2020, manymanuals.com. All rights reserved. | 0.311 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals