Lantronix SCS1620 User's Guide download pdf (Page 40)

SCSxx05/SCSxx20 User Guide 3: Quick Start

3-4

Method # 2- Using Telnet

You can use Telnet to connect to the SCS instead of using the terminal port if

your workstation is configured to communicate with the default network settings

of the SCS. The default IP address of the SCS is 10.0.0.1 with a subnet mask of

255.0.0.0. If you temporarily change your workstation to an IP address of

10.X.X.X with a subnet mask of 255.0.0.0, you can Telnet to the SCS using the

following commands:

1. To access the SCS, on the command line type telnet 10.0.0.1 and press

Enter. You should be at the login prompt at this point.

2. Log in using sysadmin as the user name and the default password, PASS.

3. Continue entering settings using the setup command. (See Configuration.)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 140 141

No comments

Lantronix SCS1620 User's Guide Page 40